Aside from formal play, a game with specific rules was published for the initial toyline. The formal game is played with two or more players. Each player is allowed up to three Beyblades, but may not switch parts once a match has started. Players may choose from any of the three Beyblades they have with them for any battle in a match.

In Metal Fight Beyblade, a points system was introduced. In the Beyblade Burst line of toys, Hasbro releases its own ruleset for its toyline. In general, the first player to 3 points will win a match.^[1]

Points are awarded to a player based on how their Beyblade looks because some Beyblades’ names vary depending on the region; the following uses the Hasbro terminology followed by the Takara Tomy ones.

• One point is awarded if the opponent's Beyblade stops spinning (Survivor/Spin Finish).
• One point is awarded if the opponent's Beyblade is knocked out of the stadium or falls into a pocket in the stadium (Ring Out/Over Finish/KO/Knockout Finish).
• Beginning with Beyblade Burst, two points are awarded if the opponent's top is "burst" during a battle (Burst Finish).

In the event of a draw (both Beyblades are knocked out of the ring, stop spinning simultaneously, or burst at the same time), no points are awarded to either player.

Three of the main types of Beyblades have rock-paper-scissors style effectiveness, with Attack generally being weak to Defense, Defense to Stamina, and Stamina to Attack. However, due to the high variability of the custom designs, this is not a hard rule. Balance types may be strong or weak to any of the others depending on specific parts.

Attack

These Beyblades specialize in attacking other Beyblades. They battle fiercely and try to knock out the other Beyblade as fast as they can, but at the cost of having poor stamina. They tend to outperform Stamina-type Beyblades due to their lack of defense. Attack-type beys also have to be heavy to be able to knock others out. They usually have flat or rubber performance tips and have layers that can grip the opponent.

Defense

These Beyblades specialize in knocking back attacks. They tend to travel slowly and are heavier than other types, resulting in opponents being deflected. Their weight also causes them to launch slower, resulting in less stamina. They tend to wear down Attack-types but are outlasted by Stamina. They are also very thick in terms of metal and have wide ball-like performance tips.

Stamina/Endurance

Stamina is the key to these Beyblades. They are used so they can out-spin the enemy top and win. In exchange for a lack of power, their stamina lasts longer against other Types of Beyblades, making them naturally advantageous over Defense-Types, which focus on resisting hits. They have sharp cone-shaped performance tips.

Balance

These Beyblades specialize in a combination of the other three types listed above, giving them no glaring strengths or weaknesses. Regardless of their strength, they combine Attack, Defense, and Stamina Types but do not excel at any of them. Some Balance Types have Attack, Defense, and Stamina Modes, and their performance tips can vary.

An arena called a Beystadium is sold by both brands Takara Tomy and Hasbro. It is primarily a shallow plastic tub, but may have other features dependent on the purpose of the particular stadium. Different stadiums were released in different markets. Brands Takara Tomy and Sonokong produce Beystadiums similar to those featured in the manga and anime adaptations, with open sections in the walls and openings on the sides to launch into. Hasbro produces stadiums with walls that are about 4.7 inches tall and pockets that count as a ring-out instead.

Common features of a Beystadium include a shallow impression called a cyclone/tornado ridge, which allows Attack type Beyblades to move around quickly without accidentally knocking themselves out, and cyclone/tornado points, which are recessed disks in the stadium floor that spin freely to add randomness to a battle. Other features may be specific to the series that the Beystadium is released in, like the rails from the Beyblade Burst Slingshock toy system, the large, almost bowl-like HyperSphere toy system.

A Beyblade Launcher (often referred to as a BeyLauncher) is used to launch the user's Beyblade into battle. Select launchers have different levels of power depending on the gears inside of them and the user's own launch strength. Launchers differ in size and shape, with some of them using Ripcords (long sticks of plastic with grips on the end and teeth on the sides to strike the gears that launch the user's Beyblade when pulled) and others using Strings (launchers that are built with a retractable string inside of them that launch the user's Beyblade with slightly more power when pulled). String Launchers are preferred by most players because of their launch power. Different series such as 2000/Original, Metal Fight/Fusion, and Burst launchers cannot be used with others.

Launching is often accompanied by a catchphrase. In the Takara Tomy version, this would be "3, 2, 1, Go Shoot!" (３、２、１、ゴーシュート!); in the Hasbro version, this would be "3, 2, 1, Let it Rip!"^[1]

The "Original Series" was the first generation of Beyblade tops. They were made entirely of plastic, with the exception of Weight Disks and some Blade Base components. These Beyblades consisted of four basic parts, the "Bit Chip," the "Attack Ring," the "Weight Disk," and the "Blade Base." It had several subsystems, such as:

• The "Magnacore" line, featuring magnetic parts to attract or repel tops from each other. Additionally, certain stadiums had points to attach magnets, which affected the movement pattern.
• The "Engine Gear" line, which was introduced with the G-series, and replaced the typical "Spin Gear" with a more advanced "Engine Gear," which affects the movement of the top during the battle.
• The "Hard/Heavy Metal System" was the last line of Beyblade toys released during the original series. It used smaller pieces made mostly of metal. However, the parts of this system cannot be used in customization with those of past systems.

This system was released in 2008 in Japan under the name "Metal Fight." A sub-system, the "Hybrid Wheel System," was released in 2009 in Japan, and was imported by Hasbro in 2010. The main difference of this sub-system from the earlier Metal System is the replacement of the lone die-cast Wheel with a combination of a plastic "Energy Ring/Clear Wheel" and "Metal/Fusion Wheel". This was done to prevent the breakage of launcher parts.^{[citation needed]} Another system, the 4D system, was introduced in 2011, focusing on slightly more complex parts. The final system, "Zero-G," focused on "Synchrome" tops, replacing certain parts for far heavier variations.

Names of Beyblades can now be determined by their parts. For example, Storm Pegasus 105RF has a 'Pegasus' Energy Ring/Clear Wheel, 'Storm' Fusion Wheel/Metal Wheel, '105(10.5mm)' Spin Track/Track, and an 'RF (Rubber Flat)' Bottom/Performance Tip.

These toys are designed so that the top may separate if it has sustained enough hits, which creates a "burst" due to a spring in the Performance Tip. The Burst System consists of 3 parts, the "Energy Layer," the "Forge Disc," and the "Performance Tip."

Toys R Us started distributing this system in Canada in September 2016^[2] and Hasbro started distributing the toys in the United States in January 2017.

As the longest-running Beyblade series, Burst has had considerably more subsystems than its predecessors. These are:

• The Dual Layer system, where the layers are made of two unseparable plastic parts.
• The God Layer/SwitchStrike system, where each "layer" has its own gimmick, and most "discs" can have plastic frames attached to increase their weight and alter performance.
• Takara Tomy's Cho-Z Layer system, in which every "layer" features metal, increasing their weight.
• The SlingShock system, which was released instead of the Cho-Z system, featuring tops with different modes, designed to climb special slingshock rails when switched to slingshock mode.
• The GT Layer system (GaTinko Layer System), which was released exclusively by Takara Tomy and featured customizable "layers," altering performance. Many "discs" in this system also began to have their own gimmicks.
• Hasbro's HyperSphere system, released as a counterpart to the GT system, features large, bowl-shaped "performance tips" designed to climb special HyperSphere walls and strike the other beyblades while descending.
• Takara Tomy's Superking/Sparking system, which altered the construction of the tops by introducing "chassis," replacements for "forge discs" that heavily increased weight. In addition, new launchers were released, which gave off sparks when used.
• The SpeedStorm system (Hasbro's equivalent to the Superking/Sparking system), features taller tops designed to gain speed or change direction in the SpeedStorm BeyStadiums.
• The Dynamite Battle Layer system (the most current iteration of Beyblade), once again features customizable "layers," this time with both a "high" and "low" mode, intended to shift the top's center of gravity. High mode is more aggressive and is easier to knock over. Low mode is more balanced and has more stamina.
• The Quaddrive system was released from Hasbro in replacement from the Dynamite Battle layer system. These layers have plastic weights, instead of the metal armours,that allow the beyblade to switch from "Core" and "Apex mode". Their drivers also feature additional pieces that increase the height and varition of how the beyblade moves along the stadium. A new Stadium was also released that features levels of playing fields that alternate the bey’s path.

• Battling Tops
• Spinja
• Ninjago
• Spin Fighters
• Battle Strikers

• Official website